data-acquisition.us

[daqmaster]

DATAX's DT3034 is a new high-performance, high-resolution DAQ board for the PCI bus. It offers 16-bit measurements on up to 32 single-ended or 16 differential channels with a sampling rate of 500kHz. With an ENOB (Effective Number of Bits) rating of over 14.2 bits, this may be one of the most accurate PCI board currently available from any manuf. SNR (Signal-to-Noise Ratio) is 100dB -- this will produce a very distortionless/clean signal from measurements. This board can operate multiple sub-systems at once at full speed without the loss of data.


Main Features:
500kHz throughput on 32 SE/16 DI, 16-bit analog input channels.
Two, 500kHz, 16-bit deglitched waveform analog output channels to generate signals to stimulate systems under test
16 clocked digital I/O driving solid state relays
Flexible triggering and clocking modes
Four 16-bit counter/timers for event counting or frequency measurement
1024-location channel-gain list for flexible scanning at many gains

More info at: http://www.datx.com/